axial cross的例句大全

INQUIRY INTO DEFORMATION OF THE AXIAL SECTION IN CROSS ROLLING WITH HELICAL GROOVES AND INVESTIGATION OF ITS EXPERIMENT IN MOIRE METHOD Research on NC Grinding of Rotary Surface Parts with Arc Axial Section and Precision Controlling

螺旋孔型斜轧轴向断面变形的探讨及云纹实验研究圆弧轴截形回转面的磨削及精度控制方法的研究

Because great changes axial cross section, stainless steel tube joint is difficult to process.

不锈钢管接头截面积变化大, 成形和脱模困难.

Because great changes are happened on its axial cross section, stainless steel tube joint is difficult to process.

不锈钢管接头截面积变化大，成形和脱模困难。

The specimen irradiated by intense laser generates distinct plastic deformation, and the profile of axial cross section of specimen after shocking is similar to a coniform figure.

结果表明：在强激光冲击下，试样发生显著的塑性变形，变形后轴截面形状为类圆锥形；

In comparison with 30 ° air inlet, the generated vortexes are fewer, weaker and nearer to the air inlets when the inlet angle is 45 ° along the axial cross section.

与30°进气道相比，沿轴向横截面上45°进气道所形成的回流区向进气道一侧偏移，回流区区域减少，强度减弱。

Study of the Inner Boundary Force of Axial Variable Cross Section Annulus Power Law Fluid

轴向变截面环空幂律流体内边界力的研究

The phenomenon of longitudinal fission seldom occurred during the process of tube plug drawing mill compared with empty-sunken steel tube. The problem which seldom cause transverse fissure in form of partial failure owing to uniform distribution of axial stress in cross section.

与空拔相比较，在短芯棒拔制过程中，纵裂现象一般不会发生，由于钢管轴向应力在横截面上分布均匀，一般也不会出现以局部破坏形式出现的横裂现象。

Numerical study on the fire stability of the axial-compression cross-section column of reinforced concrete

钢筋混凝土十字形轴压柱耐火性能的数值模拟研究

Key words: lumbar spinal morphology, spinal stenosis, positional MRI, axial load, dural sac cross-sectional area.

要害词: 腰椎形态学, 椎管狭窄, 体位MRI, 轴向负荷, 硬脊膜囊横断面积.

Study on axial deformation of workpiece in cross wedge rolling

楔横轧轧件轴向变形研究

A new method of rational selection of the cross section for ■ type of steel structure with axial compressed member

工字形钢结构轴心受压构件合理截面的选择

According to the bound failure condition of the rectangular cross section, the limit value of axial compres-sive ratio for concrete frame columns is analyzed concerning with the factor of longitudinal reinforcement, composite stirrups and core reinforcement etc.

导并计算了混凝土柱截面在界限破坏条件下的轴压比，讨论了箍筋约束、周边纵向钢筋、芯筋和其他因素对柱轴压比限值的有利影响。

The entry convergent flow pattern was observed with flow visualization technique when the resin melt flowed through a die featuring abrupt contraction in cross-section of channel and axial symmetry.

应用毛细管流变仪测量了在接近实际挤出工艺条件下低密度聚乙烯熔体的流变性质；应用流动可视化技术，观测了试样熔体流经突然收缩的轴对称口模时的入口收敛流型。

The experimental results showed that both the circumferential and axial stresses around the cross section varied in a similar "W" shape, but the former was larger than the latter in absolute valume.

实验结果表明，弯头横截面上的环向应力和轴向应力分布均呈相似的W型，但各点环向应力的绝对值均大于轴向应力。